The Bacteriastove has a heating and a cooling mode. The technical base for this is a thermo electric semiconductor
(Peltier element) which allows the Bacteriastove to reach a temperature of about 60°C or cool down 18-25°C below the ambient temperature. A digital thermostat enables setting the temperature to the desired value. The possible temperature area is about 5° to 60°C. The case is made from special thermo plastic and has goodinsulating capabilities.

Place of Installation:
The Bacteriastove has a good insulation, however outside temperatures still have an influence on the temperature inside the Bacteriastove. Place the Bacteriastove in a dry location with a fairly constant temperature. Avoid direct sunlight!

Bacteriastove Settings:
The Bacteriastove has an integrated transformer which allows you to directly connect it to the wall socket. As an option it can be used with a car adaptor and connected to 12V DC cigarette lighter. On the back of the Bacteriastove you will find the power connectors. The power cord with plug is connected to the socket marked AC 230V. If you want to use the Bacteriastove on a cigarette, plug the corresponding cable into the socket marked DC 12V. Make sure the switch on the back of the Bacteriastove is set to AC if you want to use it with 230V wall socket. For 12V operation on a cigarette lighter putthe switch on DC.Interior Lighting – Press the LIGHT button to switch on the interior lighting On/Off Switch – With the On/Off Switch on the left of the display the Bacteriastove can be switched on and off without having to pull the plug MUTE function – Put the switch on the back from NORMAL to MUTE to put the device into mute function. The fans will rotate slower and the device is quieter. At use bacteriedruk measuring aerator must be out Temperature Setting up 35°C:
Make the desired temperature setting by pressing the UP and DOWN key on the right of the display. With UP you can increase the temperature with DOWN you can decrease it. After setting the temperature the display will switch to show the current temperature. The temperature setting will be stored also during a power failure. Important:The temperature display and also the setting is an approximate value and does not 100% represent the actual temperature inside the storage area of the Bacteriastove as the temperature sensor is not placed in the storage area. There can be a difference between display and actual temperature of about -2° to -3°C in heating mode (Display 35, Actual 32°C) and +2° to +3°C in Cooling mode (Display 5, Actual approx. 8°C). Please use a
thermometer to fine adjust the temperature setting to reach the desired temperature. In the lower storage space the temperature is about 1°C lower than in the upper storage space. Temperature deviations shown in the display are normal. These are due to the functioning of the Bacteriastove as it does switch with a delay of 2°C. At a setting of 32°C the device will start heating when the temperature falls below 30°C in the display, cooling will start at 34°C. The air temperature inside the Bacteriastove will vary approximatel by 1-2°C.

Cleaning:
Pull the plug before cleaning. Use a wet cloth to clean the Bacteriastove from the outside and inside and rub it dry after cleaning. Do never rinse or spray water on the Bacteriastove. The warranty expires in case of modification and repair attempts as well as damaging by force or inappropriate usage. Neither a guarantee nor any liabilities for detriments or consequential damages in relation with this product will be assumed. Repair, amendments or exchange for a replacement are at the manufacturer’s
discretion. In case of warranty claims or repairs contact your specialist dealer. Technical Data: Operating voltage : 230V ~ 50/60 Hz, Rated Current : max 10 A, Power Consumption 230 W : approx.60 W, Power Consumption 12 V : approx. 55W